Heat Pumps are the most economical way of heating an outdoor swimming in the UK, the technology uses a system similar to that found in a domestic fridge but in reverse these units operate by extracting heat from the outside air and transferring it to the pool water using a very energy efficient technology.
The Heatinverter heat pump from Fairlocks Pool Products will easily heat any pool to the desired swimming temperature and maintain this throughout the swimming season, providing the correct size and type of heat pump is professionally selected.
With its unique system that eliminates the stop-start cycles to increase efficiency, extend the life of components, and voltage fluctuations in the load required. The result of this system reduces the demand on the compressor which in turn reduces the running cost and improves efficiency.
A traditional heat pump usually works at maximum capability or is off, as the compressor’s speed cannot be varied. To control the temperature a thermostat is used to measure the ambient air temperature and switch the compressor on when the ambient air temperature is too far from the desired temperature. The Heatinverter uses a special rectifier to convert the incoming AC current to DC and then uses pulse-width modulation of the DC current within an inverter (electrical) to produce AC current of a desired frequency to vary the compressor according to demand required.
Installing a Heat Pump ‘Heatinverter’ on your pool can provide up to six times more energy efficiency than other conventional types of heaters which use Electricity, Gas, or Oil as fuel.
The size guide is for indication only, and assumes that the pool is covered for 20 hours per day and in use for 4 hours with relative humidity of 70%.
Call us on 0800 246 5879 or email sales@watertechnics.co.uk.
Here you will find additional product details and resources.