Heat Recovery Ventilation
The Indux HR200WK is a heat recovery ventilation unit specifically designed for use in domestic kitchens and utility rooms to meet the Building Regulations. The unit is also suitable for light commercial applications up to 220m3/h (61l/s). The compact, self contained unit is designed for through-the-wall mounting.
The three speed, external rotor motor has two matched impellers to ensure a controlled airflow through the unit, with exceptionally economical 25Watt low speed power consumption.
Easy Installation
The HR200WK fits through walls up to 335mm thick requiring a fixing hole 250mm square. The internal grille has washable, polymeric foam supply and extract filters. Only the neat internal twin grille is visible from the room. A wall extension sleeve is available for walls up to 550mm thick.
Heat Exchanger
The highly efficient, polymeric heat exchanger cube is washable. The compact cube interleaves outgoing moist warm air with incoming fresh air and allows the heat from one to warm the other without the two air streams mixing. Up to 75% of the heat, which would otherwise be lost, is transferred to the intake air, ensuring energy saving ventilation.
Electrical
HR200WK 220-240V/1/50Hz Class 1 earthed appliance. The 3 speed motor, can be wired to operate On/Off for any one of the three speeds. Alternatively, an Ambient Response Humidity Sensor or simple changeover switch can be used to provide switching between any two speeds, giving permanent trickle ventilation and automatic changeover to a higher speed during periods of high moisture generation. Also the 3 speed controller enables the unit to be switched from permanent trickle to either medium or boost speed.
Typical Installation
The HR200WK fits through walls up to 335mm thick requiring a fixing hole 250mm square. The internal grille has washable, polymeric foam supply and extract filters. Only the neat internal twin grille visible from the room.
A wall extension sleeve is available.
Maintenance
Apart from removing odours, providing fresh air and recovering heat, this appliance extracts airborne impurities such as dust, dirt and grease. These gradually build up and detract from the efficiency and appearance of the appliance. Therefore to ensure peak performance, the appliance should be cleaned regularly. Filters should be replaced every six months or as conditions necessitate. Quick release grilles give instant access to the integral washable filters. The heat exchanger and grille should be washed in warm soapy water every twelve months or as conditions necessitate
Each pool is different which is why three main installation types are available:
Option 1 Through the wall Units (Indux 1 or Indux HR200)
The unit grills will be seen in the pool hall and on the external wall. Easy to install and wire up, offers a good value solution. To control the speed you will require the correct speed controller to suit your fan.
Option 2 Fully Remote (Integra Plus EC)
This is suitable for installation in roof void or similar internal space. Please note these units are not suitable for installation in wet areas or externally. The unit will have 4 spigots that you will connect 150mm ductwork too. Please check the installation and specification guides if you wish to install long runs of ductwork. These are relatively small fans so large pressure drops within the system may reduce the extraction rates. That said they are suitable for most domestic type installation. Call us for more details or download the data/installation guides from the resources tab above.
Full Range of Heat Recovery Ventilators:
Full Range of Speed Controllers Available:
Please ask if you have any questions before ordering, alternatively download the full product pdf which details sizes etc - see resources tab above. Please note some formats are not held in stock so a short lead time may apply.
This page is for an Indux HR200WK - Self Contained Through The Wall Fresh Air Heat Recovery Ventilator AM3050 (HR200WK)
Here you will find all the product details you will ever need.
